3/13/2023 0 Comments Remove timetoolConnect T-Series unit to PC RS232 serial port (or USB serial converter) using supplied console cable.The T-Series can be configured using a dumb terminal emulator, running on a PC, connected to the devices console port using the supplied serial console lead. General System Queries RS232 Serial Port Settings For Console Connection The command operand depends on model and serial number. Use “ttgnssflash -res360” or “ttgnssflash -icm360” to manually update GNSS firmware from a CLI (SSH/Console) session. If the device is powered down during the GNSS update, the update may fail when power is reapplied. Syslog ‘Error Updating GNSS Firmware’ MessageĪfter updating to firmware 2.0.003, the device will attempt to update the GNSS firmware, if necessary. The 100m cable is a LMR400 equivalent cable. The 10m, 30m and 50m cables are a LMR195 equivalent cable. A crimp tool may be required to install a surge suppressor or to customize the length of the supplied cable. Standard lengths are 10m, 30m, 50m and 100m. ![]() TimeTools provide a range of cable lengths for use with T-Series models. Correct specification and installation of the antenna and cabling is paramount.Ĭheck here for tips and pointers on troubleshooting or improving your time servers GPS/GNSS signal reception. T-Series GPS and GNSS time servers utilize a remotely located active antenna separate from the server unit. Consider temporarily disabling Windows Firewall or any Anti-Virus software! GNSS / GPS Issues No GPS / GNSS Signal Lock Ensure that UDP port 69 is open on host PC firewall.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |